ESP32 DevKitC V4 ESP 32 WROOM 32U Development Board IOT - 32U

Detail ESP32 DevKitC V4 ESP 32 WROOM 32U Development Board IOT - 32U

☑Programmers and development kits features: I/O lines on pin header
☑Ciphering: AES, WPA, WPA2-PSK, WPS
☑Protocol Supported: 802.11 b/g/n
☑Frequency: 2.4 GHz to 2.5 GHz
☑Operating Supply Voltage: 5 V
☑Series: ESP32
☑Brand: Espressif Systems
☑Interface Type: USB
☑Product Type: WiFi Development Tools
☑Interface:
☑GPIO
☑I2C x2
☑I2S x2
☑SDIO
☑SPI x3
☑UART x3
☑USB
☑Kind of connector:
☑USB micro
☑pin strips
☑Total 38 Pin

✅ 𝐅𝐄𝐀𝐓𝐔𝐑𝐄𝐒:
Built around ESP32-WROOM-32, this minimum system development board achieves optimal performance with its rich peripheral set, Wi-Fi and Bluetooth connectivity offered by our flagship SoC, ESP32. The limit is your imagination!
Rapid Prototyping
Get right into application design and development without worrying about RF performance and antenna design. ESP32-DevKitC has your basic system-requirements already covered. Just plug in the USB cable and you’re good to go!
Flexible and Feature-Rich
ESP32-DevKitC contains the entire basic support circuitry for ESP32-WROOM-32, including a USB-UART bridge, reset- and boot-mode buttons, an LDO regulator and a micro-USB connector. Every important GPIO is available to the developer.
Breadboard-Friendly
The ESP32-DevKitC pinout is optimized to enable prototyping on a breadboard. The on-board LDO output is led out for powering up additional off-board electronics. Peripheral outputs are grouped together for hassle-free prototyping.

Gambar produk