XY-L30A Baterai Charger Auto Off Over Charge DC 6-60V 30A

Detail XY-L30A Baterai Charger Auto Off Over Charge DC 6-60V 30A

XY-L30A Baterai Charger Auto Off Over Charge DC 6-60V 30A

Module Highlights:

1. Support Lead-acid battery and Acting Battery,voltage range:6V~60V;

2. Can display voltage,percent of battery,charging time at the same time through
LCD;

3. The function is very powerful,realizes the automatic charge control,

the control charge time, also may set up and uploads the corresponding parameter
through the serial port;




Function description

1. Automatic Charge control function：

By setting the volt-HI:‘UP’ volt-LI:‘dn’;When the battery voltage is below the
volt-LI:’dn’,the relay leads,the charger begins to charge the battery;when the
battery voltage is up to volt-HI:’UP’,the relay is diconnected and the automatic
charge is completed once;




2. Charge Time Control Function:

How to turn on the time control function?

After entering the parameter set, set the parameter op is non-zero, then turn on
the time control function, op default parameter is:--:--h, the default does not
turn on time control function;

After the opening Time control function (OP is non-zero), when the battery
voltage is the lower volt-LI’dn’, the charger began to charge the battery, the
system began to clock; During the timing, the battery voltage ≥ volt-HI’UP’,
relay disconnect; If the OP time is up, the battery voltage is still the lower
volt-LI’dn’, the relay keeps the conduction, automatically closes the charge
time control function, and flashes the H:ER to remind the user, the time
parameter setting is unreasonable; Press any key to stop flashing;

Note: Time format: 00:59 (00 for hours, 59 for minutes) The maximum time is
99:59, which is 100 hours.




Parameter Setting

a) Press and hold the SET key to enter the setting interface;

b) Switch the parameters you want to set by short press SET;

c) After the selection of parameters, can be set by the UP/DOWN key to support
the short press, long press (fast increase or decrease); To set other
parameters, repeat step b, c);

Gambar produk