Product Introduction Gamemax RGB series power supply offers “Value and Performance” scheme. The most suitable cost/performance ratio is the best choice for system builder. 12V CPU power and modern PCIe 6+2pin connectors are ready for high-end gaming system. Fully electrical protection and official safety are also the quality promise by Gamemax. Compatible with ATX12V 2.3 &2.4. High-end SECC black coating casing. High-Efficiency – 90+ Low Noise 14cm RGB Fan with intelligent fan speed control. Honeycomb ventilation design for optimal heat dissipation. High-end VGA card support with modern PCIe 6+2pin connector. Powerful single +12V rails offer stable DC output and support high-end graphic card and PC system. Long cable length at least 500mm supports high-end case with “Bottom”PSU position. Active Power Factor rate up to 0.9. Green power design that meets ErP requirements. Low ripple noise. OPP/OVP/UVP/SCP/OCP electrical protection included. RGB Modes operation instructions: 1. with memory function, turn on power supply again; the initial state is as same as the state of power off; 2. Press RGB controller switch successively, the lights change to be white, blue, yellow, red, green, blue green, purple, breathing lights and color mix mode in turn; 3. Breathing lights mode: make the lights bright gradually in two seconds, make the lights dim gradually in two seconds, play cycle from white color to purple color. 4. Color mix mode: the lights change from white to purple color in turn and keep 0.5S at peak of each color; it takes 4S between the two colors 5. In any mode, press the RGB controller switch for three seconds, the lights go out.