*** READY STOCK, SILAHKAN DI ORDER *** *** ALARM HEAT DETECTOR / DETEKTOR PANAS dengan FUNGSI NETWORK JARINGAN FIRE ALARM *** *** Contact Alarm Normally Close ( N.C.) ***
HEAT DETECTORis a fixed temperature heat detector. This detector is designed to provide open area protection and to be used with most conventional fire alarm panel. Two LEDs on each detector provide local 360° visible alarm indication. They flash every six seconds indicating that power is applied and the detector is working properly. The LEDs latch on in alarm. LEDs will be off when a trouble condition exists indicating that the detector sensitivity is outside the listed limit. The alarm can be reset only by a momentary power interruption. The detector that initiated the alarm condition will have its red LED and relays latched until reset by
SPECIFICATIONS Operating Voltage: 9-35 V DC Volts Non-polarized Standby Current: ≤60µA Maximum Alarm Current (LED on): ≤35 mA (1K Ohm current-limiting resistance) Operating Humidity Range: ≤95%RH(40°C±2°C) Relative Humidity, Non-condensing Operating Temperature Range: -10°C to 50°C (14°F to 122°F) Temperature Alarm Sensitivity: 57°C (135°F) AIR Height: 43.5 mm installed in Base Diameter: 98.5 mm
INSTALLATION NOTE: All wiring must conform to applicable local codes, ordinances, and regulations.