Bur kit crown and bridge toboom / Bur kit for porcelain veneer preparation toboom / bur preparasi veneer set

Detail Bur kit crown and bridge toboom / Bur kit for porcelain veneer preparation toboom / bur preparasi veneer set

merk toboomInformation:

1.SO-20: (Reminder: the maximum speed of this model is 30,0000 rpm/min) Open the proximal and distal sides of the proximal surface, and the amount of preparation is 1.0mm each, so as not to hurt the adjacent teeth. (Protection of adjacent teeth with interproximal sheet before use)

2.BR-15: Labialis and lingual preparation edge and shoulder position 0.8mm, shallow concave depth.

3.EX-52: used to find the starting end of anterior teeth with a depth of 1.5-2.0mm, and the depth is easy to control. It is used to locate the occlusal surface of the posterior teeth with a depth of 1.5-2.0mm, and the depth is easy to control.

4.EX-54: used for the transverse position of anterior teeth with a depth of 1.2-1.5mm, and the depth is easy to control.

5.TR-33: main bur, milling and positioning The remaining dental tissue in, prepares each axial surface, shoulder and coronal edge and lingual neck sleeve impression.

6.FO-23: trimming the lingual fossa to prepare the original lingual fossa shape.

7.SF-D41F: used for finishing shoulder and shaft surfaces.

8.TR-O8F: used for finishing shoulders, removing edges and non-edges.

9.TR-D36F: used for finishing any axial surfaces, occlusal surfaces, coronal edges and shoulders of teeth. The bur angle is too large, pay attention to the direction.

10.SH 3414: use a slow speed elbow to remove the occlusal surfaces and the angle of convergence of each axial surface. (Note the use of water jet polishing under the vital pulp to prevent heat build-up from stimulating the nerves of the tooth)
isi 10 pcs bur

Gambar produk